R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

63
Views
RIP view
Default command level
2: System level
Parameters
retransmit-count-value: Specifies an upper limit for retransmitting an Update Request or Update Response,
in the range of 1 to 3600.
Examples
# Configure an upper limit of 20 for retransmitting an Update Request or Update Response.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] trip retransmit count 20
trip retransmit timer
Use trip retransmit timer to configure the interval for retransmitting an Update Request or Update
Response.
Use undo trip retransmit timer to restore the default.
Syntax
trip retransmit timer retransmit-time-value
undo trip retransmit timer
Default
The default interval is 5 seconds.
Views
RIP view
Default command level
2: System level
Parameters
retransmit-time-value: Specifies an interval for retransmitting an Update Request or Update Response, in
the range of 1 to 3600 seconds.
Usage guidelines
For two routers on an analog dial-up link, the difference between retransmission intervals on the two ends
must be greater than 50 seconds; otherwise, they cannot become TRIP neighbors.
Examples
# Configure an interval of 80 seconds for retransmitting an Update Request or Update Response.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] trip retransmit timer 80