R2511-HP MSR Router Series Layer 3 - IP Routing Command Reference(V5)

64
validate-source-address
Use validate-source-address to enable the source IP address validation on incoming RIP routing updates.
Use undo validate-source-address to disable the source IP address validation.
Syntax
validate-source-address
undo validate-source-address
Default
The source IP address validation is enabled.
Views
RIP view
Default command level
2: System level
Usage guidelines
Typically HP recommends not disabling the validation.
Examples
# Disable the source IP address validation on incoming RIP routing updates.
<Sysname> system-view
[Sysname-rip] rip 100
[Sysname-rip-100] undo validate-source-address
version
Use version to specify a global RIP version.
Use undo version to remove the configured global RIP version.
Syntax
version { 1 | 2 }
undo version
Default
If an interface has a RIP version specified, the RIP version takes effect; if it has no RIP version specified,
it can send RIPv1 broadcasts, and receive RIPv1 broadcasts and unicasts, and RIPv2 broadcasts,
multicasts, and unicasts.
Views
RIP view
Default command level
2: System level
Parameters
1: Specifies the RIP version as RIPv1.
2: Specifies the RIP version as RIPv2. RIPv2 messages are multicast.