R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

127
Task Remarks
control
Configuring the maximum number of ECMP routes Optional.
Configuring IS-IS route summarization Optional.
Advertising a default route Optional.
Configuring IS-IS route redistribution Optional.
Configuring IS-IS route filtering Optional.
Configuring IS-IS route leaking Optional.
Configuring a DIS
priority for an
interface
Specifying intervals for sending IS-IS hello and CSNP packets Optional.
Specifying the IS-IS hello multiplier Optional.
Configuring a DIS priority for an interface Optional.
Disabling an interface from sending/receiving IS-IS packets Optional.
Disabling hello source address check for a PPP interface Optional.
Enabling an interface to send small hello packets Optional.
Configuring LSP parameters Optional.
Configuring SPF parameters Optional.
Assigning a high priority to IS-IS routes Optional.
Setting the LSDB overload bit Optional.
Configuring system ID to host name mappings Optional.
Enabling the logging of neighbor state changes Optional.
Enhancing IS-IS
network security
Configuring neighbor relations
hip authentication Optional.
Configuring area authentication Optional.
Configuring routing domain authentication Optional.
Configuring IS-IS GR Optional.
Enabling IS-IS SNMP trap Optional
Binding an IS-IS process with MIBs Optional
Configuring BFD for IS-IS Optional.
Configuring IS-IS basic functions
This section describes the basic settings required for an IS-IS network to run.
Configuration prerequisites
Before the configuration, complete the following tasks:
• Configure the link layer protocol.
• Configure IP addresses for all interfaces, and make sure that all neighboring nodes are reachable
to each other at the network layer.