R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

136
If a PPP interface's peer IP address is on a different network segment, disable the hello source address
check for the PPP interface to establish the neighbor relationship with the peer.
To enable neighbor relationships over different network segments:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Disable hello source
address check for the PPP
interface.
isis peer-ip-ignore
The command only applies to the PPP
interface.
By default, hello source address check
is enabled.
Enabling an interface to send small hello packets
IS-IS messages cannot be fragmented at the IP layer because they are directly encapsulated into frames.
Any two IS-IS neighboring routers must negotiate a common MTU. To avoid sending big hellos for saving
bandwidth, enable the interface to send small hello packets without CLVs.
To enable an interface to send small hello packets:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable the interface to send
small hello packets without
CLVs.
isis small-hello
Standard hello packets are sent by
default.
Configuring LSP parameters
Configuring LSP timers
1. Specify the maximum age of LSPs
Each LSP has an age that decreases in the LSDB. Any LSP with an age of 0 is deleted from the LSDB.
You can adjust the age value based on the scale of a network.
To specify the maximum age of LSPs:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify the maximum LSP
age.
timer lsp-max-age seconds
Optional.
1200 seconds by default.
2. Specify the LSP refresh interval and generation interval