R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

242
Recv Pkt Num: 57 Send Pkt Num: 53
Hold Time: 2200ms Connect Type: Indirect
Running Up for: 00:00:06 Auth mode: Simple
Protocol: BGP
Diag Info: No Diagnostic
The output shows that a BFD session is established between Ethernet 1/2 of Router A and Ethernet 1/1
of Router C and that BFD runs correctly.
# Display BGP peer information on Router C. The output shows that Router C has established two BGP
neighborships with Router A.
<RouterC> display bgp peer
BGP local router ID : 1.1.1.1
Local AS number : 200
Total number of peers : 2 Peers in established state : 2
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State
2.0.1.1 200 7 10 0 0 00:01:05 Established
3.0.1.1 200 7 10 0 0 00:01:34 Established
# Display route 1.1.1.0/24 on Router C. The output shows that Router A and Router C communicate
through Router B.
<RouterC> display ip routing-table 1.1.1.0 24 verbose
Routing Table : Public
Summary Count : 2
Destination: 1.1.1.0/24
Protocol: BGP Process ID: 0
Preference: 0 Cost: 50
NextHop: 3.0.1.1 Interface: Ethernet1/1
BkNextHop: 0.0.0.0 BkInterface:
RelyNextHop: 3.0.2.1 Neighbor : 3.0.1.1
Tunnel ID: 0x0 Label: NULL
State: Active Adv Age: 00h08m54s
Tag: 0
Destination: 1.1.1.0/24
Protocol: BGP Process ID: 0
Preference: 0 Cost: 100
NextHop: 2.0.1.1 Interface: Ethernet1/2
BkNextHop: 0.0.0.0 BkInterface:
RelyNextHop: 2.0.2.1 Neighbor : 2.0.1.1
Tunnel ID: 0x0 Label: NULL
State: Invalid Adv Age: 00h08m54s
Tag: 0
The output shows that Router C has two routes to reach network 1.1.1.0/24: Router C<—>Router
B<—>Router A, which is the active route; Router C<—>Router D<—>Router A, which is the backup
route.