R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

263
NOTE:
An ACL match criterion uses the specified ACL to match packets if the match mode is configured as permit. If the
specified ACL does not exist or the match mode is configured as deny, no packet can match the criterion.
Configuring actions for a node
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter policy node view.
policy-based-route policy-name
[ deny | permit ] node
node-number
N/A
3. Set the DF bit in the IP header
to 0, which means the packet
can be fragmented.
apply ip-df zero Optional.
4. Set VPN instances.
apply access-vpn vpn-instance
vpn-instance-name&<1-6>
Optional.
5. Set an IP precedence.
apply ip-precedence value Optional.
6. Set output interfaces.
apply output-interface
interface-type interface-number
[ track track-entry-number ]
[ interface-type interface-number
[ track track-entry-number ] ]
Optional.
You can specify up to two output
interfaces to achieve load sharing.
7. Set the output interface and
next hop (the next hop
address is the gateway
address learned through
DHCP).
apply output-interface
interface-type interface-number
ip-address next-hop dhcpc
Optional.
8. Set next hops.
apply ip-address next-hop
[ vpn-instance vpn-instance-name ]
ip-address [ direct ] [ track
track-entry-number ] [ ip-address
[ direct ] [ track
track-entry-number ] ]
Optional.
You can specify up to two next
hops to achieve load sharing.
9. Set default output interfaces.
apply default output-interface
interface-type interface-number
[ track track-entry-number ]
[ interface-type interface-number
[ track track-entry-number ] ]
Optional.
You can specify up to two default
output interfaces to achieve load
sharing.
10. Set default next hops.
apply ip-address default next-hop
[ vpn-instance vpn-instance-name ]
ip-address [ track
track-entry-number ] [ ip-address
[ track track-entry-number ] ]
Optional.
You can specify up to two default
next hops to achieve load sharing.