R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

309
Task Command Remarks
Display OSPFv3 link state
retransmission list information.
display ospfv3 [ process-id ] retrans-list [ { external |
grace | inter-prefix | inter-router | intra-prefix | link |
network | router } [ link-state-id ] [ originate-router
ip-address ] | statistics ] [ | { begin | exclude | include }
regular-expression ]
Display OSPFv3 statistics.
display ospfv3 statistics [ | { begin | exclude | include }
regular-expression ]
Display the GR status of the
specified OSPFv3 process.
display ospfv3 [ process-id ] graceful-restart status [ |
{ begin | exclude | include } regular-expression ]
OSPFv3 configuration examples
Configuring OSPFv3 areas
Network requirements
In Figure 87, all routers run OSPFv3. The AS is split into three areas, in which, Router B and Router C act
as ABRs to forward routing information between areas.
Configure Area 2 as a stub area in order to reduce LSAs in the area without affecting route reachability.
Figure 87 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure OSPFv3 basic functions:
# Configure Router A.
<RouterA> system-view
[RouterA] ipv6
[RouterA] ospfv3 1
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] ospfv3 1 area 1
[RouterA-Ethernet1/1] quit