R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

22
RIP configuration task list
Task Remarks
Configuring basic RIP Required.
Configuring RIP route
control
Configuring an additional routing metric Optional.
Configuring RIPv2 route summarization Optional.
Disabling host route reception Optional.
Advertising a default route Optional.
Configuring received/redistributed route filtering Optional.
Configuring a preference for RIP Optional.
Configuring RIP route redistribution Optional.
Tuning and optimizing
RIP networks
Configuring RIP timers Optional.
Configuring split horizon and poison reverse Optional.
Configuring the maximum number of ECMP routes Optional.
Enabling zero field check on incoming RIPv1
messages
Optional.
Enabling source IP address check on incoming RIP
updates
Optional.
Configuring RIPv2 message authentication Optional.
Specifying a RIP neighbor Optional.
Configuring TRIP Optional.
Configuring RIP-to-MIB binding Optional.
Configuring the RIP packet sending rate Optional.
Configuring BFD for RIP
Enabling single-hop echo detection (for a directly
connected RIP neighbor)
Optional.
Enabling single-hop detection in BFD echo packet
(for a specific destination)
Optional.
Enabling bidirectional control detection Optional.
Configuring basic RIP
Before you configure basic RIP settings, complete the following tasks:
• Configure the link layer protocol.
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring routers.
Enabling RIP
Perform this task to create a RIP process and enable the RIP process on the interface attached to the
specified network. An interface that is not on the specified network does not run RIP.