R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

24
With RIPv2 configured, a broadcast interface sends RIPv2 broadcasts and can receive RIPv1 unicasts,
and broadcasts, and RIPv2 broadcasts, multicasts, and unicasts.
To configure a RIP version:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify a global RIP version.
version { 1 | 2 }
Optional.
By default, if an interface has an
interface-specific RIP version, the
version takes precedence over the
global one. If no interface-specific
RIP version is specified, the
interface can send RIPv1
broadcasts, and receive RIPv1
broadcasts and unicasts, and
RIPv2 broadcasts, multicasts, and
unicasts.
4. Return to system view.
quit N/A
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Specify a RIP version for the
interface.
rip version { 1 | 2 [ broadcast |
multicast ] }
Optional.
By default, if an interface has no
RIP version specified, the global
version takes effect. If no global RIP
version is specified, the interface
can send RIPv1 broadcasts, and
receive RIPv1 broadcasts and
unicasts, and RIPv2 broadcasts,
multicasts, and unicasts.
Configuring RIP route control
Before you configure RIP routing feature, complete the following tasks:
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring routers.
• Configure basic RIP.
Configuring an additional routing metric
An additional routing metric (hop count) can be added to the metric of an inbound or outbound RIP
route.
An outbound additional metric is added to the metric of a sent route, and it does not change the route's
metric in the routing table.
An inbound additional metric is added to the metric of a received route before the route is added into the
routing table, and the route's metric is changed. If the sum of the additional metric and the original metric
is greater than 16, the metric of the route becomes 16.