R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

363
Ste
p
Command Remarks
3. Specify the AS number for the
6PE peer or peer group.
peer { ipv4-group-name |
ipv4-address } as-number as-number
Not specified by default.
4. Enter IPv6 address family
view.
ipv6-family N/A
5. Enable the 6PE peer or peer
group.
peer { ipv4-group-name |
ipv4-address | ipv6-address } enable
Not enabled by default.
6. Advertise community attribute
to the 6PE peer or peer group.
peer { group-name | ipv4-address }
advertise-community
Optional.
Not advertised by default.
7. Advertise extended
community attribute to the 6PE
peer or peer group.
peer { group-name | ipv4-address }
advertise-ext-community
Optional.
Not advertised by default.
8. Allow the local AS number to
appear in routes from the peer
or peer group and specify the
repeat times.
peer { group-name | ipv4-address }
allow-as-loop [ number ]
Optional.
Not allowed by default.
9. Specify an AS path ACL to
filter routes from or to the 6PE
peer or peer group.
peer { group-name | ipv4-address }
as-path-acl as-path-acl-number
{ import | export }
Optional.
Not configured by default.
10. Advertise a default route to
the 6PE peer or peer group.
peer { group-name | ipv4-address }
default-route-advertise [ route-policy
route-policy-name ]
Optional.
Not advertised by default.
11. Configure an inbound or
outbound IPv6 ACL based
filtering policy for the 6PE
peer or peer group.
peer { group-name | ipv4-address }
filter-policy acl6-number { import |
export }
Optional.
Not configured by default.
12. Add an 6PE peer to an
existing peer group.
peer ipv4-address group group-name
[ as-number as-number ]
Optional.
Not added by default.
13. Configure an inbound or
outbound IPv6 prefix list
based filtering policy for the
6PE peer or peer group.
peer { group-name | ipv4-address }
ipv6-prefix ipv6-prefix-name { import
| export }
Optional.
Not configured by default.
14. Keep all routes from the 6PE
peer or peer group, including
routes not passing the
inbound filtering policy.
peer { group-name | ipv4-address }
keep-all-routes
Optional.
Not kept by default.
15. Configure the device as a
route reflector and the 6PE
peer or peer group as a client.
peer { group-name | ipv4-address }
reflect-client
Optional.
Not configured by default.
16. Configure an upper limit of
IPv6 address prefixes that can
be received from the 6PE peer
or peer group.
peer { group-name | ipv4-address }
route-limit limit [ percentage ]
Optional.
No limitation by default.
17. Apply a routing policy to
routes outgoing or incoming
from the 6PE peer or peer
group.
peer { group-name | ipv4-address }
route-policy route-policy-name
{ import | export }
Optional.
Not applied by default.