R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

26
Ste
p
Command Remarks
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Disable RIPv2 automatic route
summarization.
undo summary
By default, RIPv2 automatic route
summarization is enabled.
4. Return to system view.
quit N/A
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Configure a summary route.
rip summary-address ip-address
{ mask | mask-length }
N/A
Disabling host route reception
Perform this task to disable RIPv2 from receiving host routes from the same network and save network
resources. This feature does not apply to RIPv1.
To disable RIP from receiving host routes:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Disable RIP from receiving
host routes.
undo host-route By default, RIP receives host routes.
Advertising a default route
You can advertise a default route on all RIP interfaces in RIP view or a specific RIP interface in interface
view. The interface view setting takes precedence over the RIP view settings.
To disable an interface from advertising a default route, use the rip default-route no-originate command
on the interface.
To configure RIP to advertise a default route:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Enable RIP to advertise a
default route.
default-route { only | originate }
[ cost cost ]
Optional.
Not enabled by default.
4. Return to system view.
quit N/A
5. Enter interface view.
interface interface-type
interface-number
N/A