R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

374
Origin : i - IGP, e - EGP, ? - incomplete
*> Network : 1::1 PrefixLen : 128
NextHop : FE80::E142:0:4607:1 LocPrf :
PrefVal : 0 Label : NULL
MED : 0
Path/Ogn: ?
*> Network : 2::2 PrefixLen : 128
NextHop : ::1 LocPrf :
PrefVal : 0 Label : NULL
MED : 0
Path/Ogn: ?
*>i Network : 3::3 PrefixLen : 128
NextHop : ::FFFF:3.3.3.3 LocPrf : 100
PrefVal : 0 Label : NULL
MED : 0
Path/Ogn: ?
*>i Network : 4::4 PrefixLen : 128
NextHop : ::FFFF:3.3.3.3 LocPrf : 100
PrefVal : 0 Label : NULL
MED : 0
Path/Ogn: ?
After the above configuration, you can ping through the IPv6 address 4::4 of CE 2 from CE 1.
IPv6 BGP IPsec policy configuration
Network requirements
As shown in Figure 101, configure IPv6 BGP on the routers. Routers A and B establish an IBGP
relationship. Routers B and C establish an EBGP relationship.
Configure IPsec policies on the routers to authenticate and encrypt protocol packets.
Figure 101 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure the IBGP connection:
# Configure Router A.
<RouterA> system-view