R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

381
[RouterA-Ethernet1/2] bfd authentication-mode simple 1 ibgpbfd
[RouterA-Ethernet1/2] quit
# Configure Router C.
[RouterC] bfd session init-mode active
[RouterC] interface ethernet 1/1
{ Configure the minimum interval for transmitting BFD control packets as 500 milliseconds.
[RouterC-Ethernet1/1] bfd min-transmit-interval 500
{ Configure the minimum interval for receiving BFD control packets as 500 milliseconds.
[RouterC-Ethernet1/1] bfd min-receive-interval 500
{ Configure the detect multiplier as 7.
[RouterC-Ethernet1/1] bfd detect-multiplier 7
{ Configure the BFD authentication mode as plain-text authentication, and set the authentication
key to ibgpbfd.
[RouterC-Ethernet1/1] bfd authentication-mode simple 1 ibgpbfd
[RouterC-Ethernet1/1] return
6. Verify the configuration:
The following operations are made on Router C. Operations on Router A and Router B are similar.
# Display detailed BFD session information.
<RouterC> display bfd session verbose
Total Session Num: 1 Init Mode: Active
IPv6 Session Working Under Ctrl Mode:
Local Discr: 17 Remote Discr: 13
Source IP: 3002::2
Destination IP: 3001::1
Session State: Up Interface: Ethernet1/1
Min Trans Inter: 500ms Act Trans Inter: 500ms
Min Recv Inter: 500ms Act Detect Inter: 3000ms
Recv Pkt Num: 57 Send Pkt Num: 53
Hold Time: 2200ms Connect Type: Direct
Running Up for: 00:00:06 Auth mode: Simple
Protocol: BGP6
Diag Info: No Diagnostic
The output shows that a BFD session is established between Router A's Ethernet 1/2 and Router C's
Ethernet 1/1 and that BFD runs correctly.
# Display IPv6 peer information on Router C. The output shows that the neighborship between
Router A and Router C is established.
<RouterC> display bgp ipv6 peer
BGP local router ID : 1.1.1.1
Local AS number : 200
Total number of peers : 2 Peers in established state : 2
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State