R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

28
Ste
p
Command Remarks
3. Configure a preference for
RIP.
preference [ route-policy
route-policy-name ] value
Optional.
The default setting is 100.
Configuring RIP route redistribution
Perform this task to configure RIP to redistribute routes from other routing protocols, including OSPF, IS-IS,
BGP, static, and direct routes. Only active routes can be redistributed. To display active routes, use the
display ip routing-table protocol command.
To configure RIP route redistribution:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a default metric for
redistributed routes.
default cost value
Optional.
The default setting is 0.
4. Redistribute routes from other
routing protocols.
import-route protocol [ process-id
| all-processes | allow-ibgp ] [ cost
cost | route-policy
route-policy-name | tag tag ] *
By default, route redistribution is
disabled.
Tuning and optimizing RIP networks
Configuration prerequisites
Before you tune and optimize RIP networks, complete the following tasks:
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring nodes.
• Configure basic RIP.
Configuring RIP timers
You can change the RIP network convergence speed by adjusting RIP timers. Based on network
performance, configure identical RIP timer settings to avoid unnecessary traffic or route flapping.
To configure RIP timers:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A