R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

35
Ste
p
Command Remarks
4. Enter interface view.
interface interface-type
interface-number
N/A
5. Enable BFD on the RIP
interface.
rip bfd enable Disabled by default.
NOTE:
Because the undo peer command does not remove the neighbor relationship at once, executing the
command cannot bring down the BFD session at once.
Displaying and maintaining RIP
Task Command Remarks
Display RIP current status and
configuration information.
display rip [ process-id |
vpn-instance vpn-instance-name ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display all active routes in RIP
database.
display rip process-id database [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Display RIP interface information.
display rip process-id interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display routing information about
a specified RIP process.
display rip process-id route
[ ip-address { mask | mask-length }
| peer ip-address | statistics ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Reset a RIP process. reset rip process-id process Available in user view.
Clear the statistics of a RIP process. reset rip process-id statistics Available in user view.
RIP configuration examples
Configuring RIP version
Network requirements
As shown in Figure 5, enable RIPv2 on all interfaces on Router A and Router B.