R2511-HP MSR Router Series Layer 3 - IP Routing Configuration Guide(V5)

71
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Configure a bandwidth
reference value.
bandwidth-reference value
Optional.
The value defaults to 100
Mbps.
Configuring the maximum number of ECMP routes
Perform this task to implement load sharing over ECMP routes.
To configure the maximum number of ECMP routes:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Configure the maximum
number of ECMP routes.
maximum load-balancing maximum
Optional.
By default, the
maximum number is 8.
Configuring OSPF preference
A router can run multiple routing protocols, and each protocol is assigned a preference. When the
routing protocols find routes to the same destination, the route found by the protocol with the highest
preference is selected as the best route.
To configure OSPF preference:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ] *
N/A
3. Configure a
preference for OSPF.
preference [ ase ] [ route-policy
route-policy-name ] value
Optional.
By default, the preference of OSPF
internal routes is 10, and the preference
of OSPF external routes is 150.
Configuring OSPF route redistribution
This section describes configuring OSPF to redistribute manually configured routes or routes discovered
by other routing protocols.
Only active routes can be redistributed. Use the display ip routing-table protocol command to view route
state information.