R2511-HP MSR Router Series Layer 3 - IP Services Command Reference(V5)

222
Tunneling configuration commands
bandwidth
Use bandwidth to configure the expected bandwidth for a tunnel interface.
Use undo bandwidth to remove the setting.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
Tunnel interface view
Default command level
2: System level
Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 4294967295 kbps.
Usage guidelines
You can obtain the intended bandwidth of an interface by querying the speed value of the MIB node with
third-party software.
The intended bandwidth is used for bandwidth monitoring of the network management, but does not
affect the actual bandwidth of the interface.
Examples
# Set the expected bandwidth for interface Tunnel 0 to 10000 kbps.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] bandwidth 10000
default
Use default to restore the default settings for a tunnel interface.
Syntax
default
Views
Tunnel interface view
Default command level
2: System level