R2511-HP MSR Router Series Layer 3 - IP Services Command Reference(V5)

232
Table 55 Command output
Field Descri
p
tion
*down The tunnel interface is administratively shut down by using the shutdown command.
(s)
Spoofing attribute of the tunnel interface. The link protocol state of the tunnel interface
is up, but the link does not exist, or the link is established on demand, instead of being
permanent.
Interface Name of the tunnel interface.
Physical
Physical state of the tunnel interface:
• *down—The interface has been shut down by using the shutdown command.
• down—The interface is administratively up but its physical state is down.
• up—Both the administrative and physical states of the interface are up.
Protocol
Link layer protocol state of the tunnel interface:
• down—The protocol state of the interface is down.
• up—The protocol state of the interface is up.
IPv6 Address
IPv6 address of the tunnel interface. Only the first of configured IPv6 addresses is
displayed. If no address is configured for the interface, this field displays Unassigned.
interface tunnel
Use interface tunnel to create a tunnel interface and enter tunnel interface view.
Use undo interface tunnel to delete a tunnel interface.
Syntax
interface tunnel number
undo interface tunnel number
Default
No tunnel interface is created on the device.
Views
System view
Default command level
2: System level
Parameters
number: Specifies the number of the tunnel interface. The number of tunnel interfaces that can be created
is restricted by the total number of interfaces and the memory.
Usage guidelines
Use the interface tunnel command to enter the interface view of a specific tunnel. If the specified tunnel
interface does not exist, the system creates the interface and enters its view.
A tunnel interface number is locally significant. The tunnel interfaces on the two ends of a tunnel can use
the same or different interface numbers.
All the MSR routers support this command. The following matrix shows the argument and hardware
compatibility: