R2511-HP MSR Router Series Layer 3 - IP Services Command Reference(V5)

238
Parameters
dvpn gre: Specifies the DVPN GRE tunnel mode.
dvpn udp: Specifies the DVPN UDP tunnel mode.
gre: Specifies the GRE over IPv4 tunnel mode.
gre ipv6: Specifies the GRE over IPv6 tunnel mode.
ipsec ipv4: Specifies the IPsec over IPv4 tunnel mode.
ipv4-ipv4: Specifies the IPv4 over IPv4 tunnel mode.
ipv4-ipv6: Specifies the IPv4 over IPv6 manual tunnel mode.
ipv4-ipv6 dslite-aftr: Specifies the IPv4 over IPv6 DS-lite tunnel mode on the AFTR.
ipv4-ipv6 dslite-cpe: Specifies the IPv4 over IPv6 DS-lite tunnel mode on the CPE.
ipv6-ipv4: Specifies the IPv6 over IPv4 manual tunnel mode.
ipv6-ipv4 6to4: Specifies the IPv6 over IPv4 6to4 tunnel mode.
ipv6-ipv4 auto-tunnel: Specifies the IPv6 over IPv4 automatic tunnel mode.
ipv6-ipv4 isatap: Specifies the IPv6 over IPv4 ISATAP tunnel mode.
ipv6-ipv6: Specifies the IPv6 over IPv6 tunnel mode.
mpls te: Specifies the MPLS TE tunnel mode.
Usage guidelines
You can select a tunnel mode according to the actual network topology and application. The two ends
of a tunnel must have the same tunnel mode specified. Otherwise, traffic transmission might fail.
Only one automatic tunnel can be created at the start point of a tunnel.
For more information about DVPN tunnel mode and GRE tunnel mode, see Layer 3—IP Services
Configuration Guide.
For more information about IPsec tunnel mode, see Security Configuration Guide.
For more information about MPLS TE tunnel mode, see MPLS Configuration Guide.
Examples
# Specify the IPv4 over IPv4 tunnel mode for interface Tunnel 2.
<Sysname> system-view
[Sysname] interface tunnel 2
[Sysname-Tunnel2] tunnel-protocol ipv4-ipv4