R2511-HP MSR Router Series Layer 3 - IP Services Command Reference(V5)

86
<Sysname> system-view
[Sysname] interface ethernet1/1
[Sysname-Ethernet1/1] dhcp-snooping information enable
[Sysname-Ethernet1/1] dhcp-snooping information strategy replace
[Sysname-Ethernet1/1] dhcp-snooping information format verbose
Related commands
display dhcp-snooping information
dhcp-snooping information remote-id format-type
Use dhcp-snooping information remote-id format-type to configure the code type for the
non-user-defined remote ID sub-option.
Use undo dhcp-snooping information remote-id format-type to restore the default.
Syntax
dhcp-snooping information remote-id format-type { ascii | hex }
undo dhcp-snooping information remote-id format-type
Default
The code type for the remote ID sub-option is Hex.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, WLAN-BSS interface view
Default command level
2: System level
Parameters
ascii: Specifies the code type for the remote ID sub-option as ascii.
hex: Specifies the code type for the remote ID sub-option as hex.
Usage guidelines
This command applies to configuring a non-user-defined remote ID sub-option only. After you configure
the padding content for the remote ID sub-option using the dhcp-snooping information remote-id string
command, ASCII is adopted as the code type. The private padding format only supports the hex code
type.
The following matrix shows the command in different views and hardware compatibility:
Hardware
Command in Layer 2 aggregate
interface vie
w
Command in WLAN-BSS interface
vie
w
MSR900 No Yes
MSR93X No
Yes (Supported by the JG512A,
JG519A and JG597A)
MSR20-1X No Yes
MSR20 No Yes
MSR30 Yes Yes
MSR50 Yes Yes