R2511-HP MSR Router Series Layer 3 - IP Services Configuration Guide(V5)

216
Reply from 2002:501:101:1::2: bytes=32 time=1ms
Reply from 2002:501:101:1::2: bytes=32 time<1ms
Ping statistics for 2002:501:101:1::2:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 13ms, Average = 3ms
6to4 relay configuration example
Network requirements
As shown in Figure 86, Router A is a 6to4 router, and 6to4 addresses are used on the connected IPv6
network. Router B serves as a 6to4 relay router and is connected to an IPv6 network (2001::/16).
Configure a 6to4 tunnel between Router A and Router B to make Host A and Host B reachable to each
other.
Figure 86 Network diagram
Configuration procedure
Make sure Router A and Router B can reach each other through IPv4.
The configuration on a 6to4 relay router is similar to that on a 6to4 router. However, to enable
communication between the 6to4 network and the IPv6 network, you must configure a route to the IPv6
network on the 6to4 router.
• Configure Router A:
# Enable IPv6.
<RouterA> system-view
[RouterA] ipv6
# Configure an IPv4 address for Ethernet 1/2.
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] ip address 2.1.1.1 255.255.255.0
[RouterA-Ethernet1/2] quit
# Configure an IPv6 address for Ethernet 1/1.
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] ipv6 address 2002:0201:0101:1::1/64
[RouterA-Ethernet1/1] quit