R2511-HP MSR Router Series Layer 3 - IP Services Configuration Guide(V5)

233
Internet Address is 30.1.2.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set.
Tunnel source 1::1 (Ethernet1/2)
Tunnel bandwidth 64 (kbps)
Tunnel protocol/transport IP/IPv6 dslite-cpe
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last clearing of counters: Never
Last 300 seconds input: 0 bytes/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0 packets/sec
9 packets input, 540 bytes
0 input error
9 packets output, 540 bytes
0 output error
[RouterB] display interface tunnel 2
Tunnel2 current state: UP
Line protocol current state: UP
Description: Tunnel2 Interface
The Maximum Transmit Unit is 1460
Internet Address is 30.1.2.2/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set.
Tunnel source 1::2 (Ethernet1/1)
Tunnel bandwidth 64 (kbps)
Tunnel protocol/transport IP/IPv6 dslite-aftr
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last clearing of counters: Never
Last 300 seconds input: 0 bytes/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0 packets/sec
65 packets input, 3900 bytes
0 input error
65 packets output, 3900 bytes
0 output error
# Ping the IPv4 host on the public network from the IPv4 host on the private network:
[RouterA] ping –a 10.0.0.2 20.1.1.2
PING 20.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 20.1.1.2: bytes=56 Sequence=1 ttl=255 time=1 ms
Reply from 20.1.1.2: bytes=56 Sequence=2 ttl=255 time=1 ms
Reply from 20.1.1.2: bytes=56 Sequence=3 ttl=255 time=1 ms
Reply from 20.1.1.2: bytes=56 Sequence=4 ttl=255 time=1 ms
Reply from 20.1.1.2: bytes=56 Sequence=5 ttl=255 time=1 ms
--- 20.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss