R2511-HP MSR Router Series Layer 3 - IP Services Configuration Guide(V5)

236
• Configure Router A:
# Enable IPv6.
<RouterA> system-view
[RouterA] ipv6
# Configure an IPv6 address for Ethernet 1/1.
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] ipv6 address 2002:1::1 64
[RouterA-Ethernet1/1] quit
# Configure an IPv6 address for Serial 2/0 (the physical interface of the tunnel).
[RouterA] interface serial 2/0
[RouterA-Serial2/0] ipv6 address 2002::11:1 64
[RouterA-Serial2/0] quit
# Create interface Tunnel 1.
[RouterA] interface tunnel 1
# Configure an IPv6 address for interface Tunnel 1.
[RouterA-Tunnel1] ipv6 address 3001::1:1 64
# Configure the tunnel encapsulation mode as IPv6 over IPv6.
[RouterA-Tunnel1] tunnel-protocol ipv6-ipv6
# Configure a source address for interface Tunnel 1 (IP address of Serial 2/0).
[RouterA-Tunnel1] source 2002::11:1
# Configure a destination address for interface Tunnel 1 (IP address of Serial 2/1 of Router B).
[RouterA-Tunnel1] destination 2002::22:1
[RouterA-Tunnel1] quit
# Configure a static route destined for the IPv6 network Group 2 through interface Tunnel 1.
[RouterA] ipv6 route-static 2002:3:: 64 tunnel 1
• Configure Router B:
# Enable IPv6.
<RouterB> system-view
[RouterB] ipv6
# Configure an IPv6 address for Ethernet 1/1.
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] ipv6 address 2002:3::1 64
[RouterB-Ethernet1/1] quit
# Configure an IPv6 address for Serial 2/1 (the physical interface of the tunnel).
[RouterB] interface serial 2/1
[RouterB-Serial2/1] ipv6 address 2002::22:1 64
[RouterB-Serial2/1] quit
# Create interface Tunnel 2.
[RouterB] interface tunnel 2
# Configure an IPv6 address for interface Tunnel 2.
[RouterB-Tunnel2] ipv6 address 3001::1:2 64
# Configure the tunnel encapsulation mode as IPv6 over IPv6.
[RouterB-Tunnel2] tunnel-protocol ipv6-ipv6
# Configure the source address for interface Tunnel 2 (IP address of Serial 2/1).
[RouterB-Tunnel2] source 2002::22:1