R2511-HP MSR Router Series Layer 3 - IP Services Configuration Guide(V5)

329
Ste
p
Command Remarks
4. Specify the bandwidth of the
interface for load sharing.
load-bandwidth bandwidth
Optional.
The default is the physical
bandwidth of the interface.
A bandwidth of 0 disables
routing on the interface, and
the interface is not selected
for load sharing. Other states
of the interface are not
affected.
5. Return to user view.
return N/A
6. Display statistics about
bandwidth-based load
sharing.
display load-sharing ip address
ip-address { mask | mask-length } [ |
{ begin | exclude | include }
regular-expression ]
Optional.
Available in any view.
7. Clear statistics about
bandwidth-based load
sharing.
reset load-sharing statistics ip address
ip-address { mask | mask-length }
reset load-sharing statistics all
Optional.
Configuring user-based load sharing
If both user-based load sharing and bandwidth-based load sharing are configured, user-based load
sharing applies.
To configure user-based load sharing:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable user-based load
sharing.
ip user-based-sharing enable Disabled by default.
3. Enter interface view.
interface interface-type
interface-number
N/A
4. Enable user-based load
sharing on the interface.
ip user-based-sharing enable Disabled by default.
5. Specify the bandwidth of the
interface for load sharing.
load-bandwidth bandwidth
Optional.
The default is the physical
bandwidth of the interface.
A bandwidth of 0 disables routing
on the interface, and the interface
is not selected for load sharing.
Other states of the interface are not
affected.