R2511-HP MSR Router Series MPLS Command Reference(V5)

92
If you do not specify any parameter, the command displays the AC entries of all VCs.
Examples
# Display AC information for the MPLS L2VPN.
<Sysname> display mpls l2vpn fib ac vpws
Total AC Entry:2
**In Interface : Eth1/1
Service Instance ID : 1
Access Mode : Vlan
CE Type : PortVlan
AC Encapsulation : 100
**In Interface : Eth1/1
Service Instance ID : 2
Access Mode : Vlan
CE Type : Independent
AC Encapsulation : s-vid 101 c-vid 400 to 500 600 700
# Display AC information for service instance 1 on Layer 2 Ethernet interface Ethernet 1/1.
<Sysname> display mpls l2vpn fib ac vpws interface ethernet 1/1 service-instance 1
**In Interface : Eth1/1
Service Instance ID : 1
Access Mode : Vlan
CE Type : PortVlan
AC Encapsulation : 2
InBytes : 34408752586
OutBytes : 13202790780
Table 45 Command output
Field Descri
p
tion
Total AC Entry
Total number of VPWS AC entries, which is displayed only
when you display all VPWS AC entries.
In Interface Incoming interface, which is bound to L2VPN.
AccessMode Access mode at the AC side.
CEType
Interface encapsulation type at the AC side, PortVlan or
Independent.
AC Encapsulation
Encapsulation VLAN information at the AC side. For more
information about the values of this field, see Layer 2—LAN
Switching Command Reference.
InBytes
Number of bytes received on the AC.
This field is displayed only when inbound traffic statistics is
enabled for the service instance.
OutBytes
Number of bytes sent by the AC.
This field is displayed only when outbound traffic statistics is
enabled for the service instance.