R2511-HP MSR Router Series MPLS Command Reference(V5)

97
Tunnel ID : 0x226013
Table 49 Command output
Field Descri
p
tion
CE-interface Interface connected to the CE.
CEM Class CEM class referenced by the interface.
Jitter Buffer Size Jitter buffer size, in milliseconds.
Payload Size Size of the payload of a packet, in bytes.
Idle Code Padding string to be used in case of packet loss.
VC State Data VC and signaling VC state: up, down, or blocked.
Destination Destination IP address of the VC.
VC ID VC IDs of the data VC and signaling VC.
Transmit-vpn-label
Outgoing label: label used by the data VC and signaling VC to
send VPN packets.
Receive-vpn-label
Incoming label: label used by the data VC and signaling VC to
receive VPN packets.
Tunnel Type Type of the tunnel: LSP, CR-LSP, or GRE.
l2protocol-tunnel
Use l2protocol-tunnel to enable L2PT for a protocol.
Use undo l2protocol-tunnel to disable L2PT for a protocol.
Syntax
l2protocol-tunnel { cdp | gvrp | lacp | lldp | pagp | pvst | stp | udld | vtp } { drop | tunnel
[ experimental mpls-exp-value ] | experimental mpls-exp-value }
undo l2protocol-tunnel { cdp | gvrp | lacp | lldp | pagp | pvst | stp | udld | vtp }
Default
L2PT is disabled for all procotols.
Views
Interface view
Default command level
2: System level
Parameters
cdp: Specifies the CDP protocol.
gvrp: Specifies the GVRP protocol.
lacp: Specifies the LACP protocol.
lldp: Specifies the LLDP protocol.
pagp: Specifies the PAGP protocol.
pvst: Specifies the PVST protocol.