R2511-HP MSR Router Series MPLS Command Reference(V5)

189
[Sysname] vpn popgo
# Specify the VPN label processing mode of an egress PE as FIB based forwarding.
<Sysname> system-view
[Sysname] undo vpn popgo
vpn-instance-capability simple
Use vpn-instance-capability simple to disable routing loop detection for the VPN OSPF process.
Use undo vpn-instance-capability to restore the default.
Syntax
vpn-instance-capability simple
undo vpn-instance-capability
Default
Routing loop detection is enabled for a VPN OSPF process.
Views
VPN OSPF process view
Default command level
2: System level
Usage guidelines
In an MCE network, you must disable the routing loop detection function for a VPN OSPF process on the
MCE. Otherwise, the MCE does not receive OSPF routes from the PE.
Examples
# Disable routing loop detection for the VPN OSPF process.
<Sysname> system-view
[Sysname] ospf 100 vpn-instance vpna
[Sysname-ospf-100] vpn-instance-capability simple
vpn-target (VPN instance view/IPv4 VPN view)
Use vpn-target to configure route targets for a VPN instance, an IPv4 VPN, or an IPv6 VPN.
Use undo vpn-target to remove the specified or all route targets of a VPN instance, an IPv4 VPN, or an
IPv6 VPN.
Syntax
vpn-target vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ]
undo vpn-target { all | vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ] }
Default
No route targets are configured and you must configure route targets when creating a VPN instance, an
IPv4 VPN, or an IPv6 VPN.
Views
VPN instance view, IPv4 VPN view