R2511-HP MSR Router Series MPLS Command Reference(V5)

291
Syntax
mpls te bandwidth change thresholds { down | up } percent
undo mpls te bandwidth change thresholds { down | up }
Default
The IGP flooding thresholds in both up and down directions are 10.
Views
Interface view
Default command level
2: System level
Parameters
down: Sets the threshold in percentages for IGP to flood when the bandwidth is decreasing. When the
percentage of available bandwidth decrease exceeds the threshold, the change is flooded and the traffic
engineering database (TEDB) is updated.
up: Sets the IGP flooding threshold in percentages that applies when the bandwidth is increasing. When
the percentage of available bandwidth increase exceeds the threshold, the change is flooded and the
TEDB is updated.
percent: Specifies the IGP flooding threshold in percentages, in the range of 0 to 100.
Examples
# On Ethernet 1/1 configure IGP to flood when the percentage of available bandwidth decrease
reaches 100%.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] mpls te bandwidth change thresholds down 100
mpls te commit
Use mpls te commit to submit current MPLS TE tunnel configuration.
Syntax
mpls te commit
Views
Tunnel interface view
Default command level
2: System level
Usage guidelines
The MPLS TE tunnel configuration you made can take effect only after you execute this command.
Examples
# Configure an MPLS TE tunnel and submit the configuration.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] tunnel-protocol mpls te
[Sysname-Tunnel0] destination 2.2.2.9