R2511-HP MSR Router Series MPLS Command Reference(V5)

295
After a TE class is modified, the device will notify the IGP to re-advertise the bandwidth information of all
TE interfaces, and will remove and then re-establish the CR-LSPs of the TE class on all TE interfaces.
Examples
# Associate TE class 7, CT 2, and preemption priority 3 in the IETF mode.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te ds-te ietf te-class 7 class-type 2 priority 3
Related commands
mpls te ds-te mode
mpls te ds-te mode
Use mpls te ds-te mode to specify the DS-TE mode.
Use undo mpls te ds-te mode to restore the default.
Syntax
mpls te ds-te mode ietf
undo mpls te ds-te mode
Default
The DS-TE mode is prestandard.
Views
MPLS view
Default command level
2: System level
Parameters
ietf: Specifies the DS-TE mode as IETF.
Usage guidelines
Changing the DS-TE mode will remove all CR-LSPs on the device.
Examples
# Configure the DS-TE mode as IETF.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te ds-te mode ietf
mpls te fast-reroute
NOTE:
This command is not supported when the signaling protocol is CR-LDP.
Use mpls te fast-reroute to enable the Fast Reroute (FRR) function.
Use undo mpls te fast-reroute to disable FRR.