R2511-HP MSR Router Series MPLS Command Reference(V5)

299
ospf: Sets the IGP protocol to OSPF.
Usage guidelines
The mpls te igp shortcut command cannot be used together with the mpls te igp advertise command.
Examples
# Enable OSPF and IS-IS to consider TE tunnel 0 (in up state) in its enhanced SPF calculation.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te igp shortcut
mpls te link administrative group
Use mpls te link administrative group to configure the link administrative group attribute.
Use undo mpls te link administrative group to restore the default.
Syntax
mpls te link administrative group value
undo mpls te link administrative group
Default
The link administrative group attribute is 0x00000000.
Views
Interface view
Default command level
2: System level
Parameters
value: Specifies the link administrative group attribute in the range of 0x00000000 to 0xFFFFFFFF. It is
a set of 32 link properties. Each bit represents a property with a value of 0 or 1. By ANDing the
administrative group attribute bits with the corresponding link affinity attribute bits of an MPLS TE tunnel,
MPLS TE identifies the properties of the links that the MPLS TE tunnel can use.
Usage guidelines
The interface properties are propagated globally and are used for path selection at the tunnel ingress.
Examples
# Assign Ethernet 1/1 the link administrative group attribute of 0x00000101.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] mpls te link administrative group 101
Related commands
mpls te affinity property
mpls te loop-detection
Use mpls te loop-detection to configure the node to perform loop detection when setting up the MPLS TE
tunnel.