R2511-HP MSR Router Series MPLS Command Reference(V5)

300
Use undo mpls te loop-detection to disable loop detection.
Syntax
mpls te loop-detection
undo mpls te loop-detection
Default
A node does not perform loop detection when setting up a tunnel.
Views
Tunnel interface view
Default command level
2: System level
Examples
# Configure the node to perform loop detection when setting up tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te loop-detection
mpls te max-link-bandwidth
Use mpls te max-link-bandwidth to configure the maximum bandwidth for the link to forward MPLS TE
traffic.
Use undo mpls te max-link-bandwidth to restore the default.
Syntax
mpls te max-link-bandwidth bandwidth-value
undo mpls te max-link-bandwidth
Default
The maximum link bandwidth for MPLS TE traffic is 0.
Views
Interface view
Default command level
2: System level
Parameters
bandwidth-value: Specifies the maximum bandwidth of the link, in the range of 1 to 32000000 kbps.
Usage guidelines
The configured maximum link bandwidth is available for only MPLS TE traffic.
Examples
# On Serial 1/0 set the maximum link bandwidth for MPLS TE traffic to 1158 k b ps .
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] mpls te max-link-bandwidth 1158