R2511-HP MSR Router Series MPLS Command Reference(V5)

313
Views
Tunnel interface view
Default command level
2: System level
Parameters
rsvp-te: Sets the signaling protocol for MPLS TE tunnel establishment to RSVP-TE.
crldp: Sets the signaling protocol for MPLS TE tunnel establishment to CR-LDP.
static: Sets up the tunnel using a static CR-LSP.
Usage guidelines
To use RSVP-TE as the signaling protocol for setting up the MPLS TE tunnel, you must enable both MPLS
TE and RSVP-TE on each interface for the tunnel to use.
Examples
# Adopt CR-LDP as the signaling protocol for establishing MPLS TE tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te signal-protocol crldp
mpls te tie-breaking
Use mpls te tie-breaking to specify a tie breaker that a tunnel uses to select a path when multiple paths
with the same metric are present.
Use undo mpls te tie-breaking to restore the default.
Syntax
mpls te tie-breaking { least-fill | most-fill | random }
undo mpls te tie-breaking
Default
In MPLS view, the tie breaker is random.
In tunnel interface view, no tie breaker is specified.
Views
MPLS view, tunnel interface view
Default command level
2: System level
Parameters
least-fill: Selects a path with the least bandwidth usage ratio (the used bandwidth to the maximum
reservable link bandwidth).
most-fill: Selects a path with the most bandwidth usage ratio (the used bandwidth to the maximum
reserved bandwidth).
random: Selects a path randomly.