R2511-HP MSR Router Series MPLS Command Reference(V5)

315
Related commands
mpls te auto-bandwidth
mpls te timer fast-reroute
NOTE:
This command is not supported when the signaling protocol is CR-LDP.
Use mpls te timer fast-reroute to set the FRR polling timer.
Use undo mpls te timer fast-reroute to restore the default setting.
Syntax
mpls te timer fast-reroute [ seconds ]
undo mpls te timer fast-reroute
Default
The FRR polling timer is 300 seconds.
Views
MPLS view
Default command level
2: System level
Parameters
seconds: Specifies the FRR polling timer setting for the point of local repair (PLR) to poll available bypass
tunnels for the best one. The value range is 0 to 604800 seconds, with 0 disabling the PLR to poll
available bypass tunnels regularly for the best one. The default is 300 seconds or 5 minutes.
Examples
# Set the FRR polling timer to 120 seconds or 2 minutes.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls te timer fast-reroute 120
mpls te timer link-management periodic-flooding
Use mpls te timer link-management periodic-flooding to configure the interval for advertising updated
bandwidth.
Use undo mpls te timer link-management periodic-flooding to restore the default.
Syntax
mpls te timer link-management periodic-flooding interval
undo mpls te timer link-management periodic-flooding
Default
The bandwidth advertisement interval is 180 seconds.
Views
MPLS view