R2511-HP MSR Router Series MPLS Command Reference(V5)

320
Use undo opaque-capability to restore the default.
Syntax
opaque-capability enable
undo opaque-capability
Default
The opaque LSA capability of OSPF is disabled.
Views
OSPF view
Default command level
2: System level
Parameters
enable: Enables the opaque LSA capability.
Examples
# Enable the opaque LSA capability of OSPF.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] opaque-capability enable
ping lsp te
Use ping lsp te to check MPLS TE tunnel connectivity.
Syntax
ping lsp [ -a source-ip | -c count | -exp exp-value | -h ttl-value | -m wait-time | -r reply-mode | -s
packet-size | -t time-out | -v ] * te interface-type interface-number
Views
Any view
Default command level
0: Visit level
Parameters
-a source-ip: Specifies the source IP address of the Echo Request messages to be sent.
-c count: Specifies the number of Echo Request messages to be sent. The value range for the count
argument is 1 to 4294967295, and the default is 5.
-exp exp-value: Specifies the EXP value for the Echo Request messages. The value range for the exp-value
argument is 0 to 7, and the default is 0.
-h ttl-value: Specifies the TTL value for the Echo Request messages. The value range for the ttl-value
argument is 1 to 255, and the default is 255.
-m wait-time: Specifies the interval for sending Echo Request messages. The value range for the wait-time
argument is 1 to 10000, and the default is 200, in milliseconds.
-r reply-mode: Specifies the reply mode of the receiver in response to an Echo Request message. The
reply-mode argument can be 1, 2, or 5. 1 means "Do not respond," 2 means "Respond using a UDP