R2511-HP MSR Router Series MPLS Command Reference(V5)

331
IPv6 Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-e20c-0a58
Link service is PWE3 ethernet mode
Physical is VTER, baudrate: 100000000 bps
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Table 118 Command output
Field Description
VE-L2VPN-Terminate100 current state
Physical state of the interface:
• DOWN ( Administratively )—The interface is administratively
down. It was shut down with the shutdown command.
• DOWN ( Link-Aggregation interface down )—The interface is
physically down. Reason: The aggregate interface that comprises
the current interface was shut down with the shutdown command.
• DOWN—The interface is administratively up but physically down.
Possible reason: No physical link is present or the link has failed.
• UP—The interface is both administratively and physically up.
Line protocol current state
The link layer state of the interface:
• DOWN—The interface is physically down.
• UP—The interface is physically up.
Internet protocol processing
disabled indicates that the interface cannot process IP packets. For an
interface configured with an IP address, this field changes to Internet
Address is.
Link service
Link service mode:
• PWE3 ethernet mode—The interface is configured with an MPLS
L2VPN connection, and the connection's PW encapsulation mode
is Ethernet. For information about an MPLS L2VPN connection, see
MPLS Configuration Guide.
• PWE3 vlan mode—The interface is configured with an MPLS
L2VPN connection, and the connection's PW encapsulation mode
is VLAN. For information about an MPLS L2VPN connection, see
MPLS Configuration Guide.
Physical
Physical type of the interface:
• VTER—The interface is a terminating VE interface.
• VACC—The interface is an access VE interface.
baudrate
Baud rate of the interface, namely, the maximum bandwidth of the
interface.
Last clearing of counters
Last time the reset counters interface command was executed to clear
statistics on the interface. Never indicates the reset counts interface
command has never been used on the interface since the device's
startup.
Last 300 seconds input rate Average input rate over the last 300 seconds in Bps, bps, and pps.
Last 300 seconds output rate Average output rate over the last 300 seconds in Bps, bps, and pps.