R2511-HP MSR Router Series MPLS Command Reference(V5)

332
# Display brief information about all VE-L2VPN-Terminate interfaces.
<Sysname> display interface ve-l2vpn-terminate brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
VTER20 DOWN DOWN --
VTER30 DOWN DOWN --
VTER50 DOWN DOWN --
VTER100 DOWN DOWN --
VTER200 DOWN DOWN --
VTER600 UP UP --
# Display all interfaces in down state, and the reasons why the interfaces are down.
<Sysname> display interface brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
Eth1/1 DOWN Not connected
Eth1/2 DOWN Not connected
VTER20 DOWN Not connected
VTER30 DOWN Not connected
VTER50 DOWN Not connected
VTER100 DOWN Not connected
VTER200 DOWN Not connected
VACC10 DOWN Not connected
VACC10.20 DOWN Not connected
VACC100 DOWN Not connected
The brief information of interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
Eth1/3 DOWN Not connected
Eth1/4 DOWN Not connected
Eth1/5 DOWN Not connected
Eth1/6 DOWN Not connected
Table 119 Command output
Field Description
The brief information of
interface(s) under route mode:
Brief information of Layer 3 interfaces.
Link: ADM - administratively
down; Stby - standby
• ADM—The interface has been shut down manually. To recover its
physical state, perform the undo shutdown command.
• Stby—The interface is a standby interface. You can use the display
standby state command to check the corresponding active interface.
Protocol: (s) - spoofing (s) - spoofing indicates the interface's protocol state is spoofing.