R2511-HP MSR Router Series MPLS Command Reference(V5)

63
Views
System view
Default command level
2: System level
Parameters
lsp-name: Specifies an LSP name, a string of 1 to 15 characters.
incoming-interface interface-type interface-number: Specifies an incoming interface by its type and
number.
in-label in-label: Specifies an incoming label in the range of 16 to 1023.
nexthop next-hop-addr: Specifies a next hop address.
outgoing-interface interface-type interface-number: Specifies an outgoing interface by its type and
number. This option is available only on point-to-point connections.
out-label out-label: Specifies an outgoing label, which can be a 0, 3, or a value in the range of 16 to
1023.
Usage guidelines
The next hop address cannot be any local public network IP address.
Examples
# Configure a static LSP taking the local LSR as a transit LSR, and specify the LSP's name as bj-sh,
incoming interface as Serial 2/0, incoming label as 123, next hop address as 202.34.114 . 7, a n d
outgoing label as 253.
<Sysname> system-view
[Sysname] static-lsp transit bj-sh incoming-interface serial 2/0 in-label 123 nexthop
202.34.114.7 out-label 253
Related commands
• static-lsp egress
• static-lsp ingress
statistics interval
Use statistics interval to set the interval for reading collected statistics.
Use undo statistics interval to restore the default.
Syntax
statistics interval interval-time
undo statistics interval
Default
The LSP statistics reading interval is 0, which indicates that the system does not read collected LSP
statistics.
Views
MPLS view