R2511-HP MSR Router Series MPLS Configuration Guide(V5)

150
Ste
p
Command Remarks
3. Enable RIP on the interface
attached to the specified
network.
network network-address
By default, RIP is disabled on an
interface.
4. Redistribute remote site routes
advertised by the PE.
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name |
tag tag ] *
By default, no route is redistributed
into RIP.
5. Configure the default cost
value for the redistributed
routes.
default cost value
Optional.
0 by default.
For more information about RIP, see Layer 3—IP Routing Configuration Guide.
Configuring OSPF between an MCE and a VPN site
An OSPF process belongs to the public network or a single VPN instance. If you create an OSPF process
without binding it to a VPN instance, the process belongs to the public network.
Binding OSPF processes to VPN instances can isolate routes of different VPNs. An OSPF process can
belong to only one VPN instance, but one VPN instance can use multiple OSPF processes to advertise the
VPN routes.
An OSPF process that is bound with a VPN instance does not use the public network router ID configured
in system view. Therefore, you must configure a router ID when starting the OSPF process.
To configure OSPF between an MCE and a VPN site:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an OSPF process for a
VPN instance and enter OSPF
view.
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
Perform this configuration on the
MCE. On the VPN site, create a
normal OSPF process.
3. Configure the OSPF domain
ID.
domain-id domain-id [ secondary ]
Optional.
By default, the OSPF domain ID is
0.
Perform this configuration on the
MCE.
All OSPF processes for the same
VPN must be configured with the
same OSPF domain ID to ensure
correct route advertisement.
4. Redistribute remote site routes
advertised by the PE.
import-route protocol [ process-id
| allow-ibgp ] [ cost cost | type
type | tag tag | route-policy
route-policy-name ] *
By default, no route of any other
routing protocol is redistributed
into OSPF.
5. Create an OSPF area and
enter OSPF area view.
area area-id
By default, no OSPF area is
created.
6. Enable OSPF on the interface
attached to the specified
network in the area.
network ip-address wildcard-mask
By default, an interface neither
belongs to any area nor runs
OSPF.