R2511-HP MSR Router Series MPLS Configuration Guide(V5)

190
# Execute the display ospf peer command to verify that OSPF adjacencies in Full state have been
established between each ASBR PE and the PE in the same AS, and that PEs can learn the routes
to the loopback interfaces of each other. Verify that each ASBR PE and the PE in the same AS can
ping each other. (Details not shown.)
2. Configure basic MPLS and MPLS LDP on the MPLS backbone to establish LDP LSPs:
# Configure basic MPLS on PE 1 and enable MPLS LDP on the interface connected to ASBR PE 1.
<PE1> system-view
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls
[PE1-mpls] quit
[PE1] mpls ldp
[PE1-mpls-ldp] quit
[PE1] interface pos 5/0
[PE1-POS5/0] mpls
[PE1-POS5/0] mpls ldp
[PE1-POS5/0] quit
# Configure basic MPLS on ASBR PE 1 and enable MPLS LDP on the interface connected to PE 1.
<ASBR-PE1> system-view
[ASBR-PE1] mpls lsr-id 2.2.2.9
[ASBR-PE1] mpls
[ASBR-PE1-mpls] quit
[ASBR-PE1] mpls ldp
[ASBR-PE1-mpls-ldp] quit
[ASBR-PE1] interface pos 5/0
[ASBR-PE1-POS5/0] mpls
[ASBR-PE1-POS5/0] mpls ldp
[ASBR-PE1-POS5/0] quit
# Configure basic MPLS on ASBR PE 2 and enable MPLS LDP on the interface connected to PE 2.
<ASBR-PE2> system-view
[ASBR-PE2] mpls lsr-id 3.3.3.9
[ASBR-PE2] mpls
[ASBR-PE2-mpls] quit
[ASBR-PE2] mpls ldp
[ASBR-PE2-mpls-ldp] quit
[ASBR-PE2] interface pos 5/0
[ASBR-PE2-POS5/0] mpls
[ASBR-PE2-POS5/0] mpls ldp
[ASBR-PE2-POS5/0] quit
# Configure basic MPLS on PE 2 and enable MPLS LDP on the interface connected to ASBR PE 2.
<PE2> system-view
[PE2] mpls lsr-id 4.4.4.9
[PE2] mpls
[PE2-mpls] quit
[PE2] mpls ldp
[PE2-mpls-ldp] quit
[PE2] interface pos 5/0
[PE2-POS5/0] mpls