R2511-HP MSR Router Series MPLS Configuration Guide(V5)

194
PE 1 and ASBR-PE 1 exchange labeled IPv4 routes by MP-IBGP. PE 2 and ASBR-PE 2 exchange labeled
IPv4 routes by MP-IBGP. ASBR-PE 1 and ASBR-PE 2 exchange labeled IPv4 routes by MP-EBGP.
ASBRs do not perform route target filtering of received VPN-IPv4 routes.
Figure 62 Network diagram
Device Interface IP address Device Interface IP address
PE 1 Loop0 2.2.2.9/32 PE 2 Loop0 5.5.5.9/32
Eth 1/1 30.0.0.1/8 Eth 1/1 20.0.0.1/8
S 2/0 1.1.1.2/8 S 2/0 9.1.1.2/8
A
SBR-PE 1 Loop0 3.3.3.9/32
A
SBR-PE 2 Loop0 4.4.4.9/32
S 2/0 1.1.1.1/8 S 2/0 9.1.1.1/8
S 2/1 11.0.0.2/8 S 2/1 11.0.0.1/8
Configuration procedure
1. Configure PE 1:
# Start IS-IS on PE 1.
<PE1> system-view
[PE1] isis 1
[PE1-isis-1] network-entity 10.1111.1111.1111.1111.00
[PE1-isis-1] quit
# Configure LSR ID, enable MPLS and LDP.
[PE1] mpls lsr-id 2.2.2.9
[PE1] mpls
[PE1-mpls] label advertise non-null
[PE1-mpls] quit
[PE1] mpls ldp
[PE1-mpls-ldp] quit
# Configure interface Serial 2/0, and start IS-IS and enable MPLS and LDP on the interface.
[PE1] interface serial 2/0
[PE1-Serial2/0] ip address 1.1.1.2 255.0.0.0