R2511-HP MSR Router Series MPLS Configuration Guide(V5)

270
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 BGP-VPN
instance view.
ipv6-family vpn-instance
vpn-instance-name
N/A
4. Specify an IPv6 BGP peer in
an AS.
peer ipv6-address as-number
as-number
N/A
5. Redistribute remote site
routes advertised by the PE.
import-route protocol
[ process-id [ med med-value |
route-policy route-policy-name ]
* ]
By default, No route
redistribution is configured.
6. Configure a filtering policy
to filter the routes to be
advertised.
filter-policy { acl6-number |
ipv6-prefix ip-prefix-name }
export [ direct | isisv6 process-id
| ripng process-id | static ]
Optional.
By default, the MCE does not
filter the routes to be advertised.
7. Configure a filtering policy
to filter the received routes.
filter-policy { acl6-number |
ipv6-prefix ip-prefix-name }
import
Optional.
By default, the MCE does not
filter the received routes.
NOTE:
A
fter you confi
g
ure an IPv6 BGP VPN instance, the IPv6 BGP route exchange for the IPv6 VPN
instance is the same with the normal IPv6 BGP VPN route exchan
g
e. For more information about IPv6
BGP, see
Layer 3—IP Routing Configuration Guide .
2. Configure a VPN site:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Configure the MCE as the
EBGP peer.
peer ipv6-address as-number
as-number
N/A
5. Redistribute the IGP routes
of the VPN.
import-route protocol
[ process-id [ med med-value |
route-policy route-policy-name ]
* ]
Optional.
By default, no route redistribution
is configured.
A VPN site must advertise the
IPv6 VPN network addresses it
can reach to the connected MCE.
Configuring routing between an MCE and a PE
MCE-PE routing configuration includes these tasks:
• Bind the MCE-PE interfaces to IPv6 VPN instances.
• Perform routing configurations.