R2511-HP MSR Router Series MPLS Configuration Guide(V5)

275
Task Command Remarks
Display the BGP VPNv6 routing
information of a specified VPN
instance.
display bgp vpnv6 vpn-instance
vpn-instance-name routing-table
[ network-address prefix-length
[ longer-prefixes ] | peer ipv6-address
{ advertised-routes | received-routes } ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
For commands that display information about a routing table, see Layer 3—IP Routing Command
Reference.
IPv6 MPLS L3VPN configuration examples
Configuring IPv6 MPLS L3VPNs
Network requirements
CE 1 and CE 3 belong to VPN 1. CE 2 and CE 4 belong to VPN 2.
VPN 1 uses route target attributes 111:1. VPN 2 uses route target attributes 222:2. Users of different VPNs
cannot access each other.
EBGP is used to exchange VPN routing information between CEs and PEs.
PEs use OSPF to communicate with each other and use MP-IBGP to exchange VPN routing information.
Figure 76 Network diagram
Device Interface IP address Device Interface IP address
CE 1 Eth1/1 2001:1::1/96 P Loop0 2.2.2.9/32
PE 1 Loop0 1.1.1.9/32 POS5/0 172.1.1.2/24
Eth1/1 2001:1::2/96 POS5/1 172.2.1.1/24
Eth1/2 2001:2::2/96 PE 2 Loop0 3.3.3.9/32
CE 1
Loop0
Loop0 Loop0
PE 1
PE 2
Eth1/1
Eth1/1
Eth1/2
Eth1/1
POS5/0
Eth1/1
Eth1/2
Eth1/1
Eth1/1
CE 3
CE 2
CE 4
POS5/0
POS5/1
POS5/0
VPN 1
VPN 1
VPN 2
VPN 2
MPLS backbone
AS 65410 AS 65430
AS 65420
AS 65440
P