R2511-HP MSR Router Series MPLS Configuration Guide(V5)

284
[PE1] tunnel-policy gre1
[PE1-tunnel-policy-gre1] tunnel select-seq gre load-balance-number 1
[PE1-tunnel-policy-gre1] quit
[PE1] ip vpn-instance vpn1
[PE1-vpn-instance-vpn1] route-distinguisher 100:1
[PE1-vpn-instance-vpn1] vpn-target 100:1 both
[PE1-vpn-instance-vpn1] tnl-policy gre1
[PE1-vpn-instance-vpn1] quit
[PE1] interface ethernet 1/1
[PE1-Ethernet1/1] ip binding vpn-instance vpn1
[PE1-Ethernet1/1] ipv6 address 2001:1::2 96
[PE1-Ethernet1/1] quit
# Configure PE 2.
[PE2] tunnel-policy gre1
[PE2-tunnel-policy-gre1] tunnel select-seq gre load-balance-number 1
[PE2-tunnel-policy-gre1] quit
[PE2] ip vpn-instance vpn1
[PE2-vpn-instance-vpn1] route-distinguisher 100:2
[PE2-vpn-instance-vpn1] vpn-target 100:1 both
[PE2-vpn-instance-vpn1] tnl-policy gre1
[PE2-vpn-instance-vpn1] quit
[PE2] interface ethernet 1/1
[PE2-Ethernet1/1] ip binding vpn-instance vpn1
[PE2-Ethernet1/1] ipv6 address 2001:2::2 96
[PE2-Ethernet1/1] quit
# Configure CE 1.
<CE1> system-view
[CE1] interface ethernet 1/1
[CE1-Ethernet1/1] ipv6 address 2001:1::1 96
[CE1-Ethernet1/1] quit
# Configure CE 2.
<CE2> system-view
[CE2] interface ethernet 1/1
[CE2-Ethernet1/1] ipv6 address 2001:2::1 96
[CE2-Ethernet1/1] quit
# Execute the display ip vpn-instance command on the PEs to display information about the VPN
instance. Use the ping command to test connectivity between the PEs and their attached CEs. The
PEs can ping their attached CEs. This example uses PE 1.
[PE1] display ip vpn-instance
Total VPN-Instances configured : 1
VPN-Instance Name RD Create Time
vpn1 100:1 2006/08/13 09:32:45
[PE1] ping ipv6 -vpn-instance vpn1 2001:1::1
PING 2001:1::1 : 56 data bytes, press CTRL_C to break
Reply from 2001:1::1
bytes=56 Sequence=1 hop limit=64 time = 1 ms
Reply from 2001:1::1
bytes=56 Sequence=2 hop limit=64 time = 1 ms