R2511-HP MSR Router Series MPLS Configuration Guide(V5)

308
Interface : InLoop0 Cost : 0
Destination: 2002:1::/64 Protocol : Direct
NextHop : 2002:1::1 Preference: 0
Interface : Eth1/2 Cost : 0
Destination: 2002:1::1/128 Protocol : Direct
NextHop : ::1 Preference: 0
Interface : InLoop0 Cost : 0
Destination: 2012::/64 Protocol : RIPng
NextHop : FE80::200:5EFF:FE01:1C03 Preference: 100
Interface : Eth1/2 Cost : 1
Destination: FE80::/10 Protocol : Direct
NextHop : :: Preference: 0
Interface : NULL0 Cost : 0
The output shows that the MCE has learned the private route of VPN 2 through RIPng. The MCE
maintains the routes of VPN 1 and those of VPN 2 in two different routing tables. In this way, routes
from different VPNs are separated.
3. Configure routing between the MCE and PE 1:
# The MCE is connected to PE 1 through subinterfaces. On the MCE, bind subinterface Ethernet
1/3.1 to the VPN instance vpn1, configure the subinterface to terminate VLAN 10, and configure
an IPv6 address for the subinterface.
[MCE] interface ethernet 1/3.1
[MCE-Ethernet1/3.1] ip binding vpn-instance vpn1
[MCE-Ethernet1/3.1] vlan-type dot1q vid 10
[MCE-Ethernet1/3.1] ipv6 address 2001:2::3 64
[MCE-Ethernet1/3.1] quit
# On the MCE, bind subinterface Ethernet 1/3.2 to the VPN instance vpn2, configure the
subinterface to terminate VLAN 20, and configure an IPv6 address for the subinterface.
[MCE] interface ethernet 1/3.2
[MCE-Ethernet1/3.2] ip binding vpn-instance vpn2
[MCE-Ethernet1/3.2] vlan-type dot1q vid 20
[MCE-Ethernet1/3.2] ipv6 address 2002:2::3 64
[MCE-Ethernet1/3.2] quit
# On PE 1, bind subinterface Ethernet 1/1.1 to the VPN instance vpn1, configure the subinterface
to terminate VLAN 10, and configure an IPv6 address for the subinterface.
[PE1] interface ethernet 1/1.1
[PE1-Ethernet1/1.1] ip binding vpn-instance vpn1
[PE1-Ethernet1/1.1] vlan-type dot1q vid 10
[PE1-Ethernet1/1.1] ipv6 address 2001:2::4 64
[PE1-Ethernet1/1.1] quit
# On PE 1, bind subinterface Ethernet 1/1.2 to the VPN instance vpn2, configure the subinterface
to terminate VLAN 20, and configure an IPv6 address for the subinterface.
[PE1] interface ethernet 1/1.2
[PE1-Ethernet1/1.2] ip binding vpn-instance vpn2
[PE1-Ethernet1/1.2] vlan-type dot1q vid 20
[PE1-Ethernet1/1.2] ipv6 address 2002:2::4 64
[PE1-Ethernet1/1.2] quit