R2511-HP MSR Router Series MPLS Configuration Guide(V5)

331
Task Remarks
Tuning CR-LSP setup Optional.
Tuning MPLS TE tunnel setup Optional.
Configuring traffic forwarding
Forwarding traffic along MPLS TE tunnels
using static rout
es
Required.
Use any method.
Forwarding traffic along MPLS TE tunnels
using policy routing
Forwarding traffic along MPLS TE tunnels
through automatic route advertisement
Configuring traffic forwarding tuning parameters Optional.
Configuring automatic bandwidth adjustment Optional.
Configuring CR-LSP backup Optional.
Configuring FRR Optional.
Inspecting an MPLS TE tunnel Optional.
Configuring basic MPLS TE
This configuration task includes the basic configurations required for all MPLS TE features.
Before you configure the basic MPLS TE, complete the following tasks:
• Configure static routing or IGPs to make sure all LSRs are reachable.
• Configure basic MPLS.
For information about basic MPLS configurations, see "Configuring basic MPLS."
To configure basic MPLS TE:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MPLS view.
mpls N/A
3. Enable global MPLS TE.
mpls te
Disabled by default.
4. Return to system view.
quit N/A
5. Enter the interface view of an
MPLS TE link.
interface interface-type
interface-number
N/A
6. Enable interface MPLS TE.
mpls te Disabled by default.
7. Return to system view.
quit N/A
8. Create a tunnel interface and
enter its view.
interface tunnel tunnel-number N/A
9. Assign an IP address to the tunnel
interface.
ip address ip-address netmask Optional.
10. Set the tunnel protocol to MPLS TE.
tunnel-protocol mpls te N/A
11. Configure the destination address
of the tunnel.
destination ip-address N/A