R2511-HP MSR Router Series MPLS Configuration Guide(V5)

362
# Configure Router B as the transit node on the static CR-LSP.
[RouterB] static-cr-lsp transit tunnel0 incoming-interface ethernet 1/1 in-label 20
nexthop 3.2.1.2 out-label 30
# Configure Router C as the egress node of the static CR-LSP.
[RouterC] static-cr-lsp egress tunnel0 incoming-interface ethernet 1/1 in-label 30
6. Verify the configuration:
# Execute the display interface tunnel command on Router A. The output shows that the tunnel
interface is up.
[RouterA] display interface tunnel
Tunnel0 current state: UP
Line protocol current state: UP
Description: Tunnel0 Interface
The Maximum Transmit Unit is 64000
Internet Address is 6.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 3.3.3.3
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0 packets/sec
0 packets input, 0 bytes
0 input error
0 packets output, 0 bytes
0 output error
# Execute the display mpls te tunnel command on each router to display information the MPLS TE
tunnel.
[RouterA] display mpls te tunnel
LSP-Id Destination In/Out-If Name
1.1.1.1:1 3.3.3.3 -/Eth1/1 Tunnel0
[RouterB] display mpls te tunnel
LSP-Id Destination In/Out-If Name
- - Eth1/1/Eth1/2 Tunnel0
[RouterC] display mpls te tunnel
LSP-Id Destination In/Out-If Name
- - Eth1/1/- Tunnel0
# Execute the display mpls lsp command or the display mpls static-cr-lsp command on each router
to display information about the static CR-LSP.
[RouterA] display mpls lsp
-------------------------------------------------------------------
LSP Information: STATIC CRLSP
-------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
3.3.3.3/32 NULL/20 -/Eth1/1
[RouterB] display mpls lsp
------------------------------------------------------------------
LSP Information: STATIC CRLSP