R2511-HP MSR Router Series MPLS Configuration Guide(V5)

52
Configuring VLAN encapsulation
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
{ interface-number |
interface-number.subnumber }
N/A
3. Specify the IP address or
MAC address of the default
next hop.
default-nexthop { ip ip-address |
mac { mac-address | broadcast } }
Required to support MPLS L2VPN
interworking.
By default, the default next hop
information is not specified.
This command is not available for
VLAN interfaces.
Configuring transparent ATM AAL5 frame encapsulation
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter ATM point-to-point
interface view or subinterface
view.
interface atm { interface-number |
interface-number.subnumber } p2p
N/A
3. Create a Permanent Virtual
Circuit (PVC) and enter PVC
view.
pvc { pvc-name [ vpi/vci ] |
vpi/vci }
No PVC exists by default.
You must configure the same
VPI/VCI values as those
configured on the connected CE.
4. Create a default IPoA
mapping for the PVC.
map ip default
Required to support MPLS L2VPN
interworking.
By default, no IP address mapping
exists.
For more information about PVCs and ATM interfaces, see Layer 2—WAN Access Configuration Guide.
Configuring CCC MPLS L2VPN
Configuring a local CCC connection
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a local CCC
connection on the PE to
connect two CEs.
ccc ccc-connection-name interface
interface-type interface-number
out-interface interface-type
interface-number
[ ip-interworking ]
The two interfaces specified in this
command are those connected to
the two CEs.
By specifying the two interfaces,
you bind the AC links to the CCC
connection.