R2511-HP MSR Router Series MPLS Configuration Guide(V5)

54
• Configure a primary static VC and a backup static VC on a Layer 3 interface. This method
implements VC redundancy.
Configuring a static VC on a Layer 3 interface
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter the view of the interface
connecting the CE.
interface interface-type
interface-number
N/A
3. Create a static VC.
mpls static-l2vc destination
destination-router-id
transmit-vpn-label transmit-label-value
receive-vpn-label receive-label-value
[ { control-word | ethernet |
ip-interworking | no-control-word |
vlan } | tunnel-policy
tunnel-policy-name ] *
The label range for SVCs is 16
to 1023, which is the label
range for static LSPs.
The transmit-vpn-label and
receive-vpn-label configured
on the local PE must be the
same as the receive-vpn-label
and transmit-vpn-label
configured on the peer PE.
Configuring primary and backup static VCs on a Layer 3
interface
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter the view of the interface
connecting the CE.
interface interface-type
interface-number
N/A
3. Create a primary static VC
and a backup static VC and
enter static-L2VC view.
mpls static-l2vc destination vcid
[ { control-word | ethernet |
ip-interworking | no-control-word |
vlan } | [ tunnel-policy
tunnel-policy-name ] [ backup-peer
ip-address vcid
[ backup-tunnel-policy
tunnel-policy-name | revertive
[ wtr-time wtr-time ] ] * ] ] *
By default, no primary and
backup VCs are created.
To implement VC redundancy,
use the backup-peer keyword to
create a backup VC.
4. Return to the interface view.
quit N/A
5. Switch traffic from the active
VC to the standby VC
mpls static-l2vc switchover Optional.
Configuring Martini MPLS L2VPN
To configure Martini MPLS L2VPN, complete the following tasks:
1. Configure the remote peer.
In Martini MPLS L2VPN implementation, VC labels must be exchanged between PEs. Because two
PEs might not be connected to each other directly, you must specify the peer PE as the remote peer