R2511-HP MSR Router Series MPLS Configuration Guide(V5)

66
Reply from 100.1.1.2: bytes=56 Sequence=1 ttl=255 time=2 ms
Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=3 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=3 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=2 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=3 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 2/2/3 ms
Configuring a remote CCC connection
Network requirements
The CEs are connected to the PEs through POS interfaces. The link layer encapsulation protocol is PPP.
Create a remote CCC connection, so CE 1 and CE 2 can exchange Layer 2 packets across the backbone
network.
Figure 28 Network diagram
Device Interface IP address Device Interface IP address
CE 1 POS5/0 100.1.1.1/24 CE 2 POS5/0 100.1.1.2/24
PE 1 Loop0 10.0.0.1/32 P Loop0 10.0.0.2/32
POS5/1 10.1.1.1/24 POS5/0 10.2.2.2/24
PE 2 Loop0 10.0.0.3/32 POS5/1 10.1.1.2/24
POS5/0 10.2.2.1/24
Configuration considerations
The following steps are required:
1. Create a remote CCC connection on the PEs. No static LSP is required on the PEs.
2. Enable MPLS L2VPN on the PEs. You do not need to enable MPLS L2VPN on the P device.
3. Configure two static LSPs on the P device for packets to be transferred in both directions.
Configuration procedure
1. On CE 1, configure the link protocol as PPP on POS 5/0 (the interface connected to PE 1), and
configure an IP address for the interface.