R2511-HP MSR Router Series MPLS Configuration Guide(V5)

Reply from 100.2.1.2: bytes=56 Sequence=1 ttl=255 time=30 ms

Reply from 100.2.1.2: bytes=56 Sequence=2 ttl=255 time=60 ms

Reply from 100.2.1.2: bytes=56 Sequence=3 ttl=255 time=50 ms

Reply from 100.2.1.2: bytes=56 Sequence=4 ttl=255 time=40 ms

Reply from 100.2.1.2: bytes=56 Sequence=5 ttl=255 time=70 ms

--- 100.2.1.2 ping statistics ---

5 packet(s) transmitted

5 packet(s) received

0.00% packet loss

round-trip min/avg/max = 30/50/70 ms

# Verify that CE 2 can still ping subnet 100.3.1.0/24.

[CE2] ping 100.3.1.1

PING 100.3.1.1: 56 data bytes, press CTRL_C to break

Reply from 100.3.1.1: bytes=56 Sequence=1 ttl=255 time=30 ms

Reply from 100.3.1.1: bytes=56 Sequence=2 ttl=255 time=60 ms

Reply from 100.3.1.1: bytes=56 Sequence=3 ttl=255 time=50 ms

Reply from 100.3.1.1: bytes=56 Sequence=4 ttl=255 time=40 ms

Reply from 100.3.1.1: bytes=56 Sequence=5 ttl=255 time=70 ms

--- 100.3.1.1 ping statistics ---

5 packet(s) transmitted

5 packet(s) received

0.00% packet loss

round-trip min/avg/max = 30/50/70 ms

Configuring IP interworking over Martini MPLS L2VPN

Network requirements

CE 1 and PE 1 are connected through serial interfaces and use PPP encapsulation at the link layer.

CE 2 and PE 2 are connected through Ethernet interfaces.

Establish a Martini VC, so CE 1 in the PPP network and CE 2 in the Ethernet network can communicate

with each across the backbone.

Figure 32 Network diagram